Figure 3-7. Configure Uart2 Ports; Table 3-3. Uart Ports; Table 3-4. I2C Bus - MEDIATEK Genio 700 EVK User Manual

UART
There are three UART (UART0 、UART1 and UART2) consoles with USB to UART Bridge ICs (FT232RL) on Genio 700 EVK
board. Users can use these consoles for debug purpose. The connectors are Micro USB type.
• Supports word Lengths from 5 to 8 bits with an optional parity bit and 1 or 2 stop bits
• Supports baud rates from 110 bps up to 961,200 bps
• FTDI USB to UART Bridge FT232RL
UART Port
UART0
UART1
UART2
Configure UART2 Port
Two Jumper (J4202 and J4203) to select UART2 connect to Micro USB2(CN3202) or Raspberry Pi Conn. (J4200).
I2C
• Seven I2C buses (I2C0 to I2C6)
• Supports Master Mode Only
• Adjustable clock speed for LS/FS/FS+ mode operation
• Supports 7-bit address
I2C Bus
I2C0
I2C1
I2C2
I2C3
I2C4
I2C5
I2C6
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.

Table 3-3. UART Ports

I/O Connector
CN3200 (Micro USB)
CN3201 (Micro USB)
CN3202 (Micro USB)
Schematic

Figure 3-7. Configure UART2 Ports

Table 3-4. I2C Bus

Purpose
Capacitive Touch Controller
Raspberry Pi I/O
Battery Charger
Battery Charger
Buck Convertor
USB Type C MUX
Audio DTB Connector
Raspberry Pi I/O
Capacitive Touch Controller
Camera Module CSI1
USB PD Controller
Camera Module CSI0
Camera Module CSI0
Genio 700 Evaluation Kit User Guide
Purpose
Debug
Debug
Debug
Description
(1) Jumper @ 1-2, UART2 = USB
(2) Jumper @ 2-3, UART2 = Raspberry Pi
Note
Goodix GS9271
RT9471D
RT9759
MA5721
IT5205FN/BX
Goodix GS9271
RT1715
Genio 700 EVK
19