Figure 3-7. Configure Uart2 Ports; Table 3-2. Led Indicators; Table 3-3. Uart Ports - MEDIATEK Genio 700 Hardware User's Manual

There are four LED indicators.
LED Indicators
System Power Indicator
Reset Indicator
System On Indicator
Charging Status Indicator
UART
There are three UART (UART0 、UART1 and UART2) consoles with USB to UART Bridge ICs (FT232RL) on Genio 700 EVK
board. Users can use these consoles for debug purpose. The connectors are Micro USB type.
Supports word Lengths from 5 to 8 bits with an optional parity bit and 1 or 2 stop bits.
•
Supports baud rates from 110 bps up to 961,200 bps.
•
FTDI USB to UART Bridge FT232RL
•
UARR Port
UART0
UART1
UART2
Configure UART2 Port
Two Jumper (J4202 and J4203) to select UART2 connect to Micro USB2(CN3202) or Raspberry Pi Conn. (J4200).
I2C
Seven I2C buses (I2C0 to I2C6)
•
Supports Master Mode Only
•
Adjustable clock speed for LS/FS/FS+ mode operation
•
Supports 7-bit address.
•
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.
Location Color
D1002 Green LED is on when system power in.
D3200 Green LED is on when reset key is pressed.
D1003 Green LED is on when system is on.
D1001 Red LED is on while charging.

Table 3-2. LED Indicators

I/O Connector
CN3200 (Micro USB)
CN3201 (Micro USB)
CN3202 (Micro USB)

Table 3-3. UART Ports

Schematic

Figure 3-7. Configure UART2 Ports

Genio 700 EVK Hardware User Guide
Note
Purpose
Debug
Debug
Debug
Description
(1) Jumper @ 1-2, UART2 = USB
(2) Jumper @ 2-3, UART2 = Raspberry Pi
Genio 700 EVK
16