Table of Contents
Advertisement
Genio 700 EVK
Genio 700 Evaluation Kit User Guide
6.2
Yocto
The Yocto software for Genio 700 EVK is IoT Yocto.
Please note that the enabled board hardware and supported features of IoT Yocto is different from Android.
For an overview, please refer to: https://mediatek.gitlab.io/aiot/doc/aiot-dev-guide/
Please note that then entire eMMC (except for data stored in eMMC RPMB) will be erased if you flash the board with
IoT Yocto images.
6.2.1 Yocto Software Project and Configuration
The build environment for IoT Yocto, and Yocto projects in general, is different from Android. To build Genio 700 EVK with
IoT Yocto, you need to setup Yocto build environment first:
https://mediatek.gitlab.io/aiot/doc/aiot-dev-guide/master/sw/yocto/get-started/env-setup.html
After the build environment is ready, set the bitbake MACHINE configuration to genio-700-evk. Please visit the website
for detail :
https://mediatek.gitlab.io/aiot/doc/aiot-dev-guide/master/sw/yocto/get-started/build-code.html#build-images-for-genio-
evk-boards
6.2.2 How to Get Yocto Software Image
To download the latest prebuilt board images, please visit:
https://mediatek.gitlab.io/aiot/doc/aiot-dev-guide/sw/yocto/download.html#prebuilt-board-images
6.2.3 Yocto Software Image Flash Method
IoT Yocto images uses a different tool to flash board images. Please visit the following link to install the flash tool for IoT
Yocto on your computer:
https://mediatek.gitlab.io/aiot/doc/aiot-dev-guide/master/sw/yocto/get-started/env-setup.html
After the flash tool has been installed, visit this page to flash the downloaded prebuilt image package:
https://mediatek.gitlab.io/aiot/doc/aiot-dev-guide/master/sw/yocto/get-started/flash.html
33
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.
Advertisement
Table of Contents
