Figure 3-6. Configure Uart2 Ports; Table 3-4. I2C Bus - MEDIATEK Genio 510 User Manual

Configure UART2 Port
Two Jumper (J4202 and J4203) to select UART2 connect to Micro USB2(CN3202) or Raspberry Pi Conn. (J4200).
I2C
• Seven I2C buses (I2C0 to I2C6)
• Supports Master Mode Only
• Adjustable clock speed for LS/FS/FS+ mode operation
• Supports 7-bit address
I2C Bus
I2C0
I2C1
I2C2
I2C3
I2C4
I2C5
I2C6
SPI
• Support Master/Slave mode
• One chip select output
PWM
• PWM supports old mode and FIFO mode
• The frequency can be set from 0Hz to 39MHz
MediaTek Proprietary and Confidential. © 2022 MediaTek Inc. All rights reserved. Unauthorized reproduction or disclosure of this document, in whole or in part, is strictly prohibited.
Schematic

Figure 3-6. Configure UART2 Ports

Table 3-4. I2C Bus

Purpose
Capacitive Touch Controller
Raspberry Pi I/O
Battery Charger
Battery Charger
Buck Convertor
USB Type C MUX
Audio DTB Connector
Raspberry Pi I/O
Capacitive Touch Controller
Camera Module CSI1
USB PD Controller
Camera Module CSI0
Camera Module CSI0
Genio 510 Evaluation Kit User Guide
Description
(1) Jumper @ 1-2, UART2 = USB
(2) Jumper @ 2-3, UART2 = Raspberry Pi
Note
Goodix GS9271
RT9471D
RT9759
MA5721
IT5205FN/BX
Goodix GS9271
RT1715
Genio 510 EVK
19