Upgrading Setpoint Files To A New Revision - GE GEK-113045B Manual

4 USER INTERFACE
It may be necessary to upgrade the revision code for a previously saved setpoint file when the SPM firmware is
upgraded.
1. To upgrade the revision of a previously saved setpoint file, run SPMPC and establish communications with
the SPM through the RS485 connector.
2. Select the Actual Values > Product Information menu item and record the Main Software number of the
re-lay's firmware, e.g. 201.
3. Next, select the File > Open menu item and enter the location and filename of the setpoint File to be
downloaded to the connected relay. When the file is open, SPMPC will be in "Editing File" mode and "Not
communicating".
4. Select the File > Properties menu item and note the version code of the setpoint file. If the Main Software
number of the setpoint file (e.g. 20x) is different than the Main Software number of the firmware (noted in
Step 2 as 201), use the pull-down tab to select the revision code that matches the firmware and click OK.
5. Select the File > Save menu item to save the setpoint file.
See the previous section for instructions on loading this setpoint file to the SPM relay.
GE Multilin
Courtesy of store.ips.us

4.1.7 UPGRADING SETPOINT FILES TO A NEW REVISION

SPM Synchronous Motor Protection and Control
4.1 SPMPC SOFTWARE
4-
4
7