Table of Contents
Advertisement
Fingerprint reader assembly
Description
Fingerprint reader assembly (includes cable)
Before removing the fingerprint reader assembly, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the any smart cards and memory cards.
5.
Remove the bottom cover (see
6.
Remove the battery (see
7.
Remove the memory modules (see
8.
Remove the ODD (see
9.
Remove the SSDs (see
10.
Remove the middle cover (see
Remove the fingerprint reader assembly:
1.
Disconnect the fingerprint ribbon cable (1) from the system board.
2.
Remove the Phillips M2.0×2.5 screw (2) that secures the fingerprint reader bracket to the computer.
3.
Lift the bracket (3) from atop the fingerprint reader assembly.
Service door on page
Battery on page
43).
Memory modules on page
ODD on page
48).
Solid-state drive (SSD) on page
Middle cover on page
41).
51).
46).
61).
Component replacement procedures
Spare part number
L28662-001
63
Advertisement
Table of Contents
Troubleshooting
