Fingerprint Reader Board - HP Pavilion X360 14M Maintenance And Service Manual

Fingerprint reader board

Description
Fingerprint reader board for use in full-featured models
Fingerprint reader module for use in full-featured plus models
Fingerprint bracket (included in the Miscellaneous Parts Kit)
Fingerprint reader board cable
Before removing the fingerprint reader board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet, and
then unplugging the AC adapter from the computer.
4. Remove the bottom cover (see
5. Remove the battery (see
Remove the fingerprint reader board:
1. Disconnect the cable from the fingerprint reader board ZIF connector (1).
2. Remove the Phillips M2.0×3.0 screw (2) that secures the board to the computer.
3. Lift the board out of the computer (3).
Reverse this procedure to install the fingerprint reader board.
44 Chapter 5 Removal and replacement procedures
Bottom cover on page
Battery on page 33).
31).
Spare part number
L18208-001
L18210-001
L20548-001
L18219-001