Display Assembly - HP ZBook 17 G5 Maintenance And Service Manual

Display assembly

NOTE: Touch displays are spared as a whole assembly only. Touch display assembly spare part information
is available at
level only. Additional display assembly spare part information is available at
subcomponents on page
Before removing the display assembly, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the any smart cards and memory cards.
5. Remove the bottom cover (see
6. Remove the battery (see
7. Remove the memory modules (see
8. Remove the ODD (see
9. Remove the SSDs (see
10. Remove the middle cover (see
Remove the display assembly:
1. Remove the 2 Phillips M2.5×5.0 screws (1) from the display cable bracket.
2. Disconnect the display cable (2), and then release the cable (3).
3. Disconnect the WLAN/WWAN cables (4), and then release the cables (5) from the fan routing.
4. Remove the 6 Phillips M2.5×5.0 screws (6) from the display hinges.
Computer major components on page
33.
Service door on page
Battery on page
ODD on page
Solid-state drive (SSD) on page
Middle cover on page
28. Non-touch displays are spared at the subcomponent
41).
43).
Memory modules on page
48).
46).
61).
Display assembly
51).
Component replacement procedures 89