9.
If it is necessary to replace the display hinges, remove the 4 Phillips M2.5x11.0 screws that secure each
hinge (1), and then remove the hinges from the display enclosure (2).
10.
If it is necessary to replace the display cable, lift the cable from the routing path in the display enclosure.
11.
If it is necessary to replace the camera/ambient light sensor cable:
a.
HD camera models
Disconnect the cable from the ambient light sensor board (1) and from the HD camera (2), and
then remove the cable from the display enclosure (3).
96
Chapter 6 Removal and replacement procedures for Authorized Service Provider parts