Related Manuals for Bertazzoni A304GGVXT
Summary of Contents for Bertazzoni A304GGVXT
- Page 1 INSTALLATION, USE & CARE MANUAL FREESTANDING GAS RANGES DIMENSIONS: 30’’ (762 mm)(W) x 253/16’’ (640 mm)(D) x36’’ (915 mm)(H) MODELS A304GGVXE [M7S0GNA4X(2,5)AUG] A304GGVXT [M7S0GNU4X(2,5)AUA] 310447...
- Page 2 Bertazzoni product. This manual will help you learn to use the product in the safest and most effective manner and care for it so that it may give you the highest satisfaction for years to come.
-
Page 3: Table Of Contents
TABLE OF CONTENTS WARRANTY AND SERVICE............................4 IMPORTANT SAFETY INFORMATION ........................5 PRODUCT SPECIFICATIONS............................6 INSTALLATION BEFORE INSTALLATION ............................7 INSTALLING THE LEGS .............................. 8 INSTALLING THE WORKTOP FRONTGUARD (OPTIONAL) ................... 8 INSTALLING THE BACKGUARD..........................10 INSTALLING THE ANTI‐TIP STABILLTY DEVICE......................11 INSTALLATION REQUIREMENTS .......................... -
Page 4: Warranty And Service
WARRANTY AND SERVICE All Bertazzoni products carry a 2 year parts and labor warranty. Service on all Bertazzoni products shall be carried out by factory‐trained professionals only. For warranty service please contact Customer Service at the numbers indicated below. CUSTOMER SERVICE English/spanish hotline (866) 905‐0010... -
Page 5: Important Safety Information
WARNING! IMPORTANT SAFETY INFORMATION Read this instruction booklet before installing PLEASE READ AND FOLLOW THESE IMPORTANT and using the appliance. INSTRUCTIONS FOR THE SAFETY OF YOUR HOME The manufacturer will not be responsible for AND OF THE PEOPLE LIVING IN IT. any damage to property or to persons caused by Save this Manual for local electrical inspector’s incorrect installation or improper use of the... -
Page 6: Product Specifications
PRODUCT SPECIFICATIONS Dimensions (insert drawings front, side and back Weight Burner power Auxiliary 3400 BTU/h Semi‐rapid 6100 BTU/h Rapid 10400 BTU/h Dual burner (inner) 2800 BTU/h Dual burner ( outer) 12000 BTU/h Oven 14500 BTU/h broiler 12000 BTU/h... -
Page 7: Before Installation
WARNING! BEFORE INSTALLATION Do not use aerosol sprays in the vicinity of this This appliance shall only be installed by an appliance while it is in operation authorized professional. ROOM VENTILATION: An exhaust fan may be This appliance shall be installed in accordance used with the appliance;... -
Page 8: Installing The Legs
INSTALLING THE LEGS INSTALLING THE HOB RAIL AND OVEN HANDLE Bertazzoni ranges must be used only with the legs properly installed. Only model A304GGVXT The rail and handle are packed with the upstand. Four height‐adjustable legs are shipped with the range in the polysterene container situated over The rail is only available on some models. -
Page 9: Installing The Worktop Frontguard (Optional)
INSTALLING THE WORKTOP FRONTGUARD Only model A304GGVXE To increase the clearance between the front edge of the worktop and the burners it is possible to install the worktop frontguard shipped with the appliance. To install the front guard, hold it with the pointed edges looking up. -
Page 10: Installing The Backguard
2 lateral screws from the bottom. INSTALLING THE BACKGUARD The backguard must be installed prior to operation of the appliance for appropriate ventilation of the oven compartment. The supplied backguard is a 2‐part assembly. The box also contains a set of metal screws for securing the backguard to the worktop. -
Page 11: Installing The Anti-Tip Stabillty Device
INSTALLING THE ANTI‐TIP STABILlTY INSTALLATION REQUIREMENTS DEVICE The anti‐tip bracket shipped with the range must ELECTRICAL be properly secured to the rear wall as shown in the pircture below. A properly‐grounded horizontally‐ mounted The height of the bracket from the floor must be electrical receptacle should be installed no higher determined after the range legs have been than 3"... -
Page 12: Installation Adjacent To Kitchen Cabinets
This range may be installed directly adjacent to been designed to work in conjunction with the existing countertop high cabinets (36" or 91.5 cm Bertazzoni range and have the same finish for a from the floor). perfect look. For the best look, the worktop should be level For maximum performance, the height of the with the cabinet countertop. -
Page 13: Electrical Connection
WARNING! ELECTRICAL CONNECTION ELECTRICAL SHOCK HAZARD This unit is manufactured for a polarized, Disconnect electrical power at the circuit grounded 120 volt/60 Hz, 15 amp system. breaker box or fuse box before installing the Electric power consumption is about 300 W. appliance. -
Page 14: Gas Connection
MANUAL SHUT‐OFF VALVE GAS CONNECTION THIS VALVE IS NOT SHIPPED WITH THE APPLIANC All gas connections must comply with national AND MUST BE SUPPLIED BY THE INSTALLER. and local codes. The gas supply line (service) The manual shut‐off valve must be installed in must be the same size or greater than the inlet the gas service line between the gas hook‐up on line of the appliance. - Page 15 PRESSURE REGULATOR Since service pressure may fluctuate with local demand, every gas cooking appliance must be equipped with a pressure regulator on the incoming service line for safe and efficient operation. The pressure regulator shipped with the appliance has has two female threads ½” NPT. The regulator shall be installed properly in order to be accessible when the appliance is installed in its final position.
-
Page 16: Gas Conversion
STEP 1: PRESSURE REGULATOR GAS CONVERSION The pressure regulator supplied with the appliance is a convertible type pressure regulator WARNING! for use with Natural Gas at a nominal outlet Before carrying out this operation, disconnect pressure of 4” w.c. or LP gas at a nominal outlet the appliance from gas and electricity. -
Page 17: Step 2: Surface Burners
7 mm {sochet wrench). Remove the oven door Replace nozzles using the conversion set supplied with the range or by a Bertazzoni authorized parts warehouse. Each nozzle has a number indicating its flow diameter printed on the body. -
Page 18: Step 4: Broiler Burner
ATTENTION: pay extra attention to avoid damage to the igniter and thermocouple. nozzle. Replace the nozzle using the conversion set supplied with the range or by a Bertazzoni authorized parts warehouse. Each nozzle has a Re‐install all the parts in revers sequence number indicating its flow diameter printed on the body. -
Page 19: Step 5: Visual Checks
STEP 5: VISUAL CHECKS Before reinstalling the bottom panel, the following visual check must be performed to ensure that the conversion has been carried out properly and without damage to other components of the range. A) CONNECTION OF THERMOCOUPLES TO THERMOSTAT The thermocouples for both broiler and main oven burner are connected to the same magnet. -
Page 20: Step 6: Minimum Flame Adjustment
OVEN BURNER STEP 6: MINIMUM FLAME ADJUSTMENT 1. Set the oven temperature control knob to the MAXIMUM setting. WARNING! 2. Close the oven door and operate the oven for at least 10 minutes. These adjustments should be made only for use of the appliance with natural gas. - Page 21 Models A304GGVXE [M7S0GNA4X(2,5)AUG] A304GGVXT [M7S0GNU4X(2,5)AUA] Burner Position Injector Pressure Max Rate Min Rate By-pass diam. [mm.] Type [i.w.c.] [BTU/h] [BTU/h] diam. [mm] Auxiliary Rear L 0,90 4” 3400 Regulated 0,54 LP (Propane) 11” 3400 0,29 Semi-Rapid Front R 1,18 4”...
-
Page 22: Installation Checkllst
INSTALLATION CHECKLlST FINAL PREPARATION 1. Is the range mounted on its legs? Before using the oven, remove any protective wrap from the stainless steel. 2. Is the backguard securely connected? All stainless steel body parts should be wiped with hot, soapy water and with a liquid stainless 3. -
Page 23: User Manual
USER MANUAL SURFACE BURNER LAYOUT WARNING! Reflect names from brochure 1. Small Burner Do not to cover the holes inside the oven with 2. Medium burner aluminium foil. 3. Rapid burner Do not to cover the worktop with aluminium 4. Dual burner (Power burner) foil. -
Page 24: Surface Cooking
SURFACE BURNER OPERATION SURFACE COOKING THERMOCOUPLE SAFETY VALVE SYMBOLS Each surface burner of a Bertazzoni range is equipped with a thermocouple safety device. The thermocouple opens the flow of gas to the burner only when hot. Should the flame go off,... -
Page 25: Tips For Using Burners Correctly
TIPS FOR USING BURNERS CORRECTLY TIPS FOR USING PANS CORRECTLY WARNING! ATTENTION! KEEP CHILDREN AT A SAFE DISTANCE FROM THE Always ensure that bottom and handles of pans APPLIANCE DURING OPERATION. do not protrude from the worktop. DO NOT ALLOW CHILDREN TO OPERATE THE When cooking with flammable fat such as oil, do APPLIANCE. -
Page 26: Oven Cooking
OVEN COOKING SYMBOLS Convection fan and oven compartment light switch Oven compartment light switch for baking or broiling Thermal bake selector Broiler selector Recommended control knob position for burner ignition 270F Mimimum oven temperature setting 500F Maximum oven temperature setting Oven on/off Oven status indicator. -
Page 27: Oven Shelves
Insert the shelf between top and bottom guide in any of the 4 positions available. THERMOCOUPLE SAFETY VALVE Bertazzoni gas ovens are equipped with a thermocouple safety device and a thermostat to set the proper cooking temperature. The thermocouple opens the flow of gas to the burner only when hot. -
Page 28: Convection Cooking
ELECTRIC IGNITION CONVECTION COOKING Bertazzoni gas oven are equipped with a WARNING! CONVECTION fan. Always keep the oven door open when lighting In convection mode, the fan situated at the back the oven. of the oven compartment creates horizontal Warning: Do not use the gas oven or broiler in forced‐air... -
Page 29: Cooking With The Gas Broiler
WARNING USING THE THERMOMETER Always keep the oven door open when lighting Only model A304GGVXT the gas broiler. The range is fitted with a device that gives a quantitative indication of the temperature in the The gas broiler is activated with the same control middle of the oven. -
Page 30: Maintaining Your Range
Dry thoroughly before Bertazzoni ranges are equipped with a cooling using them again. Before reinstalling them on the fan. The fan starts operating each time the oven burner head, check that the gas flow holes are knob is on a position different from 0 (zero). -
Page 31: Important Appliance Information
IMPORTANT APPLIANCE INFORMATION MODEL ______________________________________________________________ DATE INSTALLED _______________________________________________________________ DEALER _______________________________________________________________ _______________________________________________________________ INSTALLER _______________________________________________________________ ________________________________________________________________ SERVICER _______________________________________________________________ ________________________________________________________________... - Page 32 BERTAZZONI SpA Via Palazzina 8 42016 Guastalla RE ITALY WWW.BERTAZZONI‐ITALIA.COM...
- Page 33 SPARE PARTS LIST NUMBER COMPONENT DESCRIPTION QUANTITY M7S0GNA4X5AUG A304GGVXE - GAS COOKER 6010008 WIRE T-ZERO 601758 CIRCUIT DIAGRAM 202631 BURNERS FLASK 202432 PART FOR DUAL WOK AND SEMI RAPID BURNERS 306003 THERMOSTAT CLIP 306002 SPRING FOR KNOB 504160 COVER FOR SMALL FLAME SPREADER 504161 COVER FOR MEDIUM BURNER 504162...
- Page 34 510512 DUAL BURNER 502148 GAS VALVE BY PASS 036 502150 GAS VALVE BY PASS 065 502179 GAS VALVE BY PASS 029 502180 GAS VALVE BY PASS 047 200327 STAINLESS STEEL SIDE 202389 RIGHT VERTICAL VENT 202214 FEET SUPPORT 201197 FIXING FOR WORK TABLE 308031 BUMPER FOR C.I.
- Page 39 SPARE PARTS LIST NUMBER COMPONENT DESCRIPTION QUANTITY M7S0GNA4X5AUA A304GGVXT - GAS COOKER 6010008 WIRE T-ZERO 601758 CIRCUIT DIAGRAM 202631 BURNERS FLASK 202432 PART FOR DUAL WOK AND SEMI RAPID BURNERS 306003 THERMOSTAT CLIP 306002 SPRING FOR KNOB 504160 COVER FOR SMALL FLAME SPREADER...
- Page 40 200327 STAINLESS STEEL SIDE 202389 RIGHT VERTICAL VENT 202214 FEET SUPPORT 201197 FIXING FOR WORK TABLE 308031 BUMPER FOR C.I. GRIDS AND DISHWARMER 403463 HANDLE TERMINAL 403463 HANDLE TERMINAL 403464 HANDLE TERMINAL 403464 HANDLE TERMINAL 403465 FIXING HANDLE TERMINAL 403465 FIXING HANDLE TERMINAL 408076 CAST IRON PAN SUPPORT...