Summary of Contents for Bertazzoni Professional Series
Page 1
INSTALLATION MANUAL USER AND MAINTENANCE MANUAL FREESTANDING ELECTRIC RANGES, CERAMIC WORKTOP, ELECTRIC MANUAL CLEAN OVEN MODEL www.bertazzoni.com...
Page 3
Bertazzoni becomes a real pleasure. This manual will help you learn to use and care for your Bertazzoni appliance in the safest and most effective way, so that it can give you the highest satisfaction for years to come.
Page 5
USER MANUAL VALIDITY The following manual is valid for all the product codes mentioned below: • MAS304CEMXV • PRO304CEMXV...
All other servicing should be referred to a qualified servicer. FOR THE INSTALLER: Before installing the Bertazzoni appliance, please read these instructions carefully. This appliance shall be installed in accordance with the manufacturer’s installation instructions.
WARNINGS DO NOT lift the range by the oven door’s handle, as this may damage the door hinges and cause the door to fit incorrectly. DO NOT lift the appliance by the range’s control panel. The unit is heavy and should be handled accordingly. Proper safety equipment such as gloves and adequate manpower of at least two people must be used in moving the range to avoid injury and to avoid damage to the unit or...
BEFORE INSTALLATION • This appliance shall only be installed by an authorized professional. • This appliance shall be installed in accordance with the manufacturer’s installation instructions. • This appliance must be installed in accordance with the norms & standards of the country where it will be installed.
VENTILATION PREPARATION This range will best perform when installed with Bertazzoni exhaust hoods. These hoods have been designed to work in conjunction with the Bertazzoni range and have the same finish for a perfect look. Before installation of the exhaust hood, consult local or regional building and installation codes for additional specific clearance requirements.
CLEARANCE DIMENSIONS INSTALLATION ADJACENT TO KITCHEN METAL HOOD CABINETS 30″(76.20 cm) This range may be installed directly adjacent to existing 25 1/2″(65 cm) and 31 1/2″ (80 cm) countertop high cabinets (36″ or 91.5 cm from the floor). 13″ (33.0 cm) For the best look, the worktop should be level with the 18″...
INSTALLATION REQUIREMENTS ELECTRICAL properly-grounded horizontally-mounted electrical receptacle should be installed no higher than 3″ (7.6 cm) above the floor, no less than 2″ (5 cm) and no more than 8″ (20.3 cm) from the left side (facing product). Check all local code requirements. Fig.
ELECTRICAL CONNECTION WARNING ELECTRICAL SHOCK HAZARD Disconnect electrical power at the circuit breaker box or fuse box before installing the appliance. Provide appropriate ground for the appliance. Use copper conductors only. Failure to follow these instructions could result in serious injury or death. ELECTRICAL GROUNDING This appliance is equipped with a three-prong plug for your Fig.
WIRING DIAGRAM The electric wiring diagrams and schematics are attached behind the range, and should not be removed except by a service technician, then replaced after service. Fig. 8...
INSTALLATION APPLIANCE INSTALLATION UNPACKING THE RANGE • Remove all packing materials from the shipping pallet but leave the adhesive-backed foam layer over brushed- metal surfaces to protect it from scratches until the range is installed in its final position. Only the film on the side panels should be removed before inserting the range between the cabinets.
INSTALLATION INSTALLING THE LEGS INSTALLING THE WORKTOP FRONTGUARD Bertazzoni ranges must be used only with the legs properly To increase the clearance between the front edge of the installed. worktop and the burners, it is possible to install a front guard for the worktop.
INSTALLATION INSTALLING THE ISLAND TRIM INSTALLING BACKGUARD (OPTIONAL) The island trim must be installed prior to operation of the The backguard must be installed prior to operation of the appliance appropriate ventilation oven appliance appropriate ventilation oven compartment. compartment. The island trim is only placed on the cooktop, remove all The backguard is an optional contact you dealer for buying tape and packaging before installing it.
INSTALLING THE ANTI-TIP DEVICES ANTI-TIP BRACKETS The anti-tip bracket shipped with the range must be properly secured to the rear wall as shown in the picture below. The height of the bracket from the floor must be determined after the range legs have been adjusted to the desired height and after the range has been levelled.
INSTALLATION CHECKLIST A qualified installer should carry out the following checks: Range mounted on its legs Island trim or Backguard attached according to instruction Anti-tip device properly installed Clearance to cabinet surfaces as manufacturer’s guideline...
FINAL PREPARATION • Before using the oven, remove any protective wrap from the stainless steel. • All stainless steel body parts should be wiped with hot, soapy water and with a liquid stainless steel cleanser. • If buildup occurs, do not use steel wool, abrasive cloths, cleaners, or powders! •...
We have a dedicated team of trained 866 905 0010 professionals to answer your needs. https://us.bertazzoni.com/more/support If you own a Bertazzoni appliance and need service in the If located in CANADA: US or Canada please use the following contact information: 800 561 7265 https://ca.bertazzoni.com/more/support...
WARNINGS Warning and Important Safety Instructions appearing in this In Massachusetts: manual are not meant to cover all possible conditions and All gas products must be installed by a “Massachusetts” situations that may occur. licensed plumber or gasfitter. A “T” handle type manual gas Common sense, caution, and care must be exercised when valve must be installed in the gas line connected to this installing, maintaining, or operating the appliance.
WARNINGS IN CASE OF FIRE Turn off appliance and ventilation hood to avoid spreading the flame. Extinguish flame then turn on hood to remove smoke and odor. • Cooktop: Smother fire or flame in a pan with a lid or cookie sheet.
WARNINGS COOKING SAFETY • DO NOT cook directly on the oven bottom. This could result in damage to your appliance. Always use the oven racks when cooking in the oven. • Once the unit has been installed as outlined in the Installation Instructions, it is important that the fresh air Do not connect any appliances to the plugs above or near supply is not obstructed.
WARNINGS CERAMIC COOKING SURFACES CLEANING SAFETY • Surface areas on or adjacent to the unit may be hot • Turn off all controls and wait for appliance parts to cool enough to cause burns. Do not touch the cooking area before touching or cleaning them.
WARNINGS ELECTRICAL SHOCK HAZARD WARNING-TIPPING HAZARD Make sure all controls are OFF and oven is COOL before Children and adults can tip over the range if it has not been cleaning. Failure to do so can result in burns or electrical secured.
WORKTOP AND KNOBS LAYOUT Fig. 20 Heating element Left rear induction element 6″ 1/8 (155mm) Right rear element 7″ 1/2 (190mm) Left front induction element 8″ 1/4 (210mm) Right front element 6″ 1/8 (155mm) Oven thermostat Oven functions selector...
COOKTOP USING THE CERAMIC HOB The working table has 5 cooking areas, which differ in power and diameter. Positions are clearly indicated with screen-printed round areas (see description of the hobs). The heating process comes inside these areas. When a worktop hotplate is used for some time, the remaining surface remain hot;...
COOKTOP WARNING Do not touch the cooking area as long as the light indicating residual heat on the glass-ceramic hob, is “on”; this indicates that the temperature in the relative area is still high. WARNING Your glass-ceramic hob is thermal shock resistant and resistant to both heat and cold.
ELECTRIC CONVECTION OVEN USING THE OVEN WARNING Attention! When using the oven for the first 1) Place rack in desired position and shut the door. time it should be operated for 15-30 2) Select the oven function with the dedicated function minutes at a temperature of about 500℉/ knob.
ELECTRIC CONVECTION OVEN UPPER BAKE CONVECTION Heat from upper element only. Heat from the convection element and airflow convection with fan. Use this setting for browning and reheating dishes such as Use this mode for most recipes being careful at calibrating lasagne, moussaka and cauliflower cheese.
ELECTRIC CONVECTION OVEN CONDENSATION GETTING THE BEST RESULTS • Minimize opening and closing the oven door during It is normal for a certain amount of moisture to evaporate operation. from the food during any cooking process. The amount depends on the moisture content of the food. The moisture •...
ELECTRIC CONVECTION OVEN BROILING RECOMMENDATION FOOD ITEM CONTROL APPROXIMATE COOKING SPECIAL INSTRUCTIONS TEMPERATURE SETTING TIME AND TIPS SELECTOR BEEF 500℉ fixed temperature 15 to 20 minutes Broil until no pink in center setting Ground Beef Patties, ½″ thick T-Bone Steak 500℉...
ELECTRIC CONVECTION OVEN TROUBLESHOOTING COMMON PROBLEMS WITH OVEN COOKING REMEDY PROBLEMS CAUSE Cakes burned on the sides or not Oven too hot Reduce temperature done in center Use recommended pan size Wrong pan size Cakes crack on top Batter too thick Follow recipe or add liquid Oven too hot Reduce temperature...
ELECTRIC CONVECTION OVEN TELESCOPIC GLIDES The telescopic glides fit any shelf level and work with the wire shelves provided as standard equipment. FITTING THE GLIDES 1) Locate the two spring clips at the front and back of the glides. 2) Locate the pin on the glide that indicates the back. 3) Choose the right level and position the telescopic glide near the upper wire.
KEEPING YOUR BERTAZZONI CLEAN BURN HAZARD CLEANING THE BROILER PAN Make sure the heating elements are turned off and allowed Clean with detergent and hot water. For stubborn spots, to cool completely before any cleaning and/or maintenance use a soap-filled steel wool pad.
Please call our toll free line to identify service technicians in your area: If located in the US, BC, B, Sk and MB 866 905 0010 https://us.bertazzoni.com/more/support Fig. 31 If located in CANADA, ON, QC, PE, NU, NS, NL, NB •...
Page 41
SIMPLE MAINTENANCE TOP OVEN LIGHT Bulb type: halogen G9 120 V, 40 W • Make sure the heating elements are turned off and allowed to cool completely. Disconnect the appliance from the power supply. • Unscrew the glass cover and remove the halogen bulb. •...
GRILLING IN THE OVEN IS SLOW Here are answer to common problems you may experience. You are also welcome to call our toll free Customer Service line to troubleshoot any issue with your Bertazzoni. Have you selected the correct function? CONDENSATION FORMS IN THE OVEN...
866 905 0010 https://us.bertazzoni.com/more/support Bertazzoni’s liability on any claim of any kind, with respect to the goods and/or services provided, shall in no event If located in CANADA exceed the value of the goods or service or part thereof which gives origin to the claim.
• Use of the Product for anything other than its intended In no case shall Bertazzoni be held liable or responsible for purpose. damage to surrounding property, including furniture, • Repair service provided by a party other than a cabinetry, flooring, panels and other structures surrounding Bertazzoni authorized service agency.
Page 45
MISUSE OR INABILITY TO USE THIS PRODUCT, REGARDLESS OF THE LEGAL THEORY ON WHICH THE CLAIM IS BASED, AND EVEN IF BERTAZZONI HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES. NOR SHALL RECOVERY OF ANY KIND AGAINST BERTAZZONI BE GREATER IN AMOUNT...