Installing/Removing Non-Adjustable Angle Stroller Handles; Installing/Removing Adjustable Angle Stroller Handle - Invacare Solara 3G Service Manual

Installing/Removing Non-Adjustable Angle Stroller Handles

NOTE: For this procedure, refer to FIGURE 6.5.
Installing
1. Remove the plug buttons from both back canes, if
necessary.
2. Slide non adjustable angle stroller handle into the back
canes.
3. Align the mounting holes of the non adjustable angle
stroller handle and the back canes.
4. Insert the quick release pin through the back cane and
non adjustable angle stroller handle.
5. Repeat STEP for remaining back cane.
6. Pull on the non adjusted angle stroller handle to make
sure it is locked securely in place.
Removing
1. Remove the quick release pins that secure the non
adjustable angle stroller handle to the back cane.
2. Remove the non adjustable angle stroller handle from
the wheelchair.

Installing/Removing Adjustable Angle Stroller Handle

Installing
NOTE: For this procedure, refer to FIGURE 6.6.
1. Position each stroller handle gear inside each back cane.
2. Secure stroller handle gear to the back canes with two mounting screws and locknuts. Tighten securely.
Removing
1. Remove the two mountings screws and locknuts that secure the stroller handle gears to the back canes.
2. Remove the adjustable angle stroller handle from the back canes.
Adjustable Angle
Stroller Handle
Part No 1160889
FIGURE 6.6 Installing/Removing Adjustable Angle Stroller Handle
Stroller Handle
Mounting
Hole
Mounting
Hole
FIGURE 6.5 Installing/Removing Non-Adjustable Angle
Locknut
33
SECTION 6—BACK
Quick Release Pin
with Laynard
Back
Cane
Stroller Handles
Mounting
Screw
Back
Cane
Solara®3G/Spree 3G