Invacare Solara 3G Service Manual page 32

SECTION 6—BACK
Mounting
Screws
Locknut
FIGURE 6.3 Assembling/Disassembling the Stroller Handle - Non Adjustable Angle Stroller Handle
Adjustable Angle Stroller Handle
NOTE: For this procedure, refer to FIGURE 6.4.
1. Secure the crossbrace tube to the push handle assemblies at the desired width with two mounting screws and locknuts.
Tighten securely.
NOTE: When performing STEP 2 the actuator button can be mounted toward the inside or outside of the wheelchair.
2. Secure one stroller handle gear to each push handle assembly with mounting screw and locknut. Tighten securely.
3. Install the stroller handle. Refer to Installing/Removing Adjustable Angle Stroller Handle on page 33
4. Disassemble by reversing STEPS 1‐3.
Mounting Screw
Push Handle
Mounting
Screw
FIGURE 6.4 Assembling/Disassembling the Stroller Handle - Adjustable Angle Stroller Handle
Solara®3G/Spree 3G
Non Adjustable Angle Stroller Handle
Crossbrace
Tube
Adjustment
Stroller Handle
Assembly
Adjustable Angle Stroller Handle
Adjustment
Holes
Crossbrace
Locknut
Stroller
Handle Gear
Mounting
Screws
Holes
Locknut
Quick Release Pin
with Laynard
Quick Release Pin
with Laynard
Mounting Screw
Locknut
Tube
Locknut
Locknut
32
Insert
Tube
Mounting
Screw
Stroller
Handle Gear
Actuator
Button
Part No 1160889