Invacare Solara 3G Service Manual page 131

Ensure that the recline trigger release lever operating the RIGHT gas cylinder secures to the
LEFT side of the adjustable angle stroller handle and that the recline trigger release lever operat-
ing the LEFT gas cylinder secures to the RIGHT side of the adjustable angle stroller handle,
allowing the cables to form an "X" pattern (Detail "A" of FIGURE 14.1). Otherwise, damage to
the cables may occur.
5. While standing behind the wheelchair, secure the recline trigger release lever operating the right gas cylinder to the left
side of the adjustable angle stroller handle with the existing mounting screw and locknut (Detail ʺCʺ). Securely tighten.
DO NOT over tighten the new cable into the actuator housing. Damage to the actuator housing
can occur.
6. Screw the end of the new recliner cable into the actuator housing until the cable is tightened securely (Detail ʺBʺ).
7. Install the end of the recliner cable onto the actuator (Detail ʺBʺ).
NOTE: Make sure the recliner cable is positioned in the slot in the actuator.
8. Secure the recline cables to the back canes using new tie wraps (Detail "C").
9. Repeat Removing on page 130 and Installing on page 130 for the opposite recliner cable, if necessary.
10. Test the operation of the gas cylinders. Refer to Adjusting the Gas Cylinders on page 134.
Part No 1160889
CAUTION
CAUTION
131
SECTION 14—RECLINER BACK
Solara®3G/Spree 3G