Invacare Solara 3G Service Manual page 152

SECTION 17—INSTALLING LOW SHEAR RECLINER
Outside Backrest Bracket
Use This Mounting Hole
Top
Mounting
Screw
Outside Backrest Bracket
Bottom
Mounting
Screw
Use This
Mounting Hole
NOTE: Refer to FIGURE 17.8 on page 155 for correct hardware orientation.
NOTE: Right and left hand side is determined from the seated position in the wheelchair.
Inside Backrest Bracket
Top
Mounting
Screw
Inside Backrest Bracket
Bottom
Mounting
Screw
NOTE: Refer to FIGURE 17.8 on page 155 for correct hardware orientation.
NOTE: Right and left hand side is determined from the seated position in the wheelchair.
Solara®3G/Spree 3G
CORRECT MOUNTING HOLES TO USE FOR 2 INCH SHEAR
Right Hand Components
Use This Mounting Hole
Left Hand Components
Use This
Recess facing
Mounting
inside of
Hole
wheelchair
Use This
Mounting
Use This
Mounting
Hole
Upper Link
Recess facing
NOTE: The upper link
that is used on the left
inside of
hand side for 3.8 inch and
wheelchair
3 inch shear will be used
on the right hand side for
2 inch shear. Ensure the
recessed area is facing
toward the inside of the
chair.
Bottom Link
Use This
Mounting
Hole
Upper Link
NOTE: The upper link
that is used on the right
hand side for 3.8 inch
and 3 inch shear will be
used on the left hand side
for 2 inch shear. Ensure
the recessed area is
facing toward the inside
Hole
of the chair.
Lower Link
Use This
Mounting
Hole
152
Inside Backrest Bracket
Use This
Mounting
Hole
Inside Backrest Bracket
Use This
Mounting
Hole
Outside Backrest Bracket
Use This Mounting Hole
Outside Backrest Bracket
Use This
Mounting Hole
Part No 1160889