Installing Fixed Height Stroller Handles; Installing/Removing/Adjusting The Adjustable Angle Stroller Handles - Invacare Orbit Owner's Operator And Maintenance Manual

Installing Fixed Height Stroller Handles

NOTE: For this procedure, refer to FIGURE 7.2.
1. Remove the back cane grip and plug button from the back cane.
2. Slide the stroller handle into the back cane.
3. Align the mounting holes of the stroller handle and the back cane.
4. Press the button on the quick‐release pin and insert the quick‐release pin through the
back cane and stroller handle.
5. Repeat STEPS 1‐4 for the opposite stroller handle.
6. Pull on the stroller handle to make sure it is locked securely in place
Stroller
Handle
FIGURE 7.2 Installing Fixed Height Stroller Handles
Installing/Removing/Adjusting the Adjustable Angle
Stroller Handles
NOTE: Stroller handles install in the same manner for recliner and non‐recliner models.
Installing Adjustable Angle Stroller Handles
NOTE: For this procedure, refer to FIGURE 7.3 on page 54.
1. Remove the back cane grips and plug buttons from both back canes.
NOTE: Plug buttons found only on recliners.
2. Slide the adjustable height stroller handle into the back canes.
3. Align the mounting holes of the adjustable height stroller handle and the back cane.
4. Secure adjustable height stroller handle to the back canes with the two mounting
screws provided. Securely tighten.
5. If necessary, adjust the height. Refer to Adjusting Adjustable Angle Stroller Handles
on page 54.
Part No. 1073955
Plug Button
(STEP 1)
Button
Quick-Release Pin
SECTION 7—SEAT AND BACK
Back Cane
Grip (STEP 1)
Back Cane
53 ™
Orbit