Bolt Torque Specifications; Stud And Wheel Nut Torque Specifications - J&M TB-6000 Trail-Blazer Operator's Manual

Hide thumbs Also See for TB-6000 Trail-Blazer:

Operator's manual (30 pages)

Table of Contents

Always tighten hardware to these values unless a different torque or tightening procedure is listed for specific application. Fasteners must

always be replaced with the same grade as specified in the manual parts list. Always use the proper tool for tightening hardware. Make

sure fastener threads are clean and you start thread engagement properly. Use these values when tightening all bolts and nuts with

the exception of wheel nuts.

Always tighten hardware to these values unless a different torque or tightening procedure is listed for specific application. Fasteners must

always be replaced with the same grade as specified in the manual parts list. Always use the proper tool for tightening hardware. Make

sure fastener threads are clean and you start thread engagement properly. Use these values when tightening all studs and wheel

nuts.

TIGHTENING WHEEL NUTS: Torque 9/16"-18 lug nuts on wheels to 170 ft-lbs during initial operation of the header wagon. Check

for proper torque after every 10 hours of use. Failure to do so may damage wheel nut seats. Once seats are damaged it will become

impossible to keep nuts tight.