Section Iii: Directions For Use; To Change Lounger Height; Backrest Operation - OAKWORKS Cabana Lounger Instruction Manual

DIRECTIONS FOR USE

TO CHANGE LOUNGER HEIGHT

Each leg has a self retaining spring loaded pin to adjust the height of the
table. Put the table on its side so that all 4 legs are horizontal. Be sure to lay
the lounger on a protective surface to prevent lounger damage.
Pull pin out and move the leg to the desired height. Release the pin and it
will fit lock into a hole in the leg. Repeat this procedure for all four legs.

BACKREST OPERATION

lift slightly
lift slightly
then lower backrest to the desired position.
5
TO RAISE THE BACKREST
The Cabana Lounger has an adjustable
backrest with 6 fixed positions. To raise the
backrest, lift the top at the head end of the
table. Raise backrest to the desired height and
release. Backrest support arm will lock in the
nearest slot in the side rail.
TO LOWER THE BACKREST
To lower the backrest, lift the backrest
slightly, lift and hold the support arm out
of the slot and lower the backrest to the
desired position.