Table of Contents
Advertisement
PHI 3100
Machine actions
No hot water or steam is
dispensed. Only for PHI
3100 AMF-CMF
The machine does not turn
on.
No hot water is dispensed.
Only for PHI 3100 OTC
Milk does not froth. Only
for PHI 3100 AMF
The milk is not frothed or
will not come out. Only for
PHI 3100 OTC
The descaling cycle cannot
be completed.
Note:
* These problems can be considered normal if the coff ee blend has been changed or if the machine has just been
installed. In this case wait until the machine performs a self-adjusting operation as described in the "Saeco Adapting
System" chapter.
Causes
The hole of the steam/hot
water wand is clogged.
The circuit is not primed.
The machine circuit is
clogged by limescale.
The Classic Milk Frother is
dirty. Only for PHI 3100
CMF
The circuit is not primed.
The machine circuit is
clogged by limescale.
The Automatic Milk Froth-
er is inserted too deep. No
milk is being suctioned.
The milk carafe is dirty or
not inserted correctly.
The
carafe
dispensing
spout has not been re-
moved correctly.
The milk carafe is not fully
assembled.
The type of milk used is
not suitable for frothing.
The
water
dispensed
for the rinse cycle is not
enough.
03 BRIEF INSTRUCTIONS
Solution
Clean the hole of the steam wand
using a pin.
Make sure that the machine is off
and has cooled down before per-
forming this operation.
Prime the circuit.
Descale the machine.
Clean the Classic Milk Frother.
Prime the circuit.
Descale the machine.
Leave the Automatic Milk Frother to
cool down. Move it slightly downwards.
Reposition it in its correct seat.
Clean the carafe and insert it correctly.
Check that the milk dispensing spout
has been removed correctly.
Make sure that all components have
been correctly assembled.
Use the type of milk.
Press the on/off button and follow the
instructions described in the "Inter-
ruption of the Descaling Cycle" section
of the User Manual.
9/9
Advertisement
Table of Contents
