Knoll Stroke 665/420 User Manual page 5

DANGER —Risk of
electric shock, injury,
or death
1. Improper usage, abuse, or misuse of the power supply,
handset, motors and other electrical components may
result in an electrical shock injury or possible death.
2. Do not open the power supply unit or handset under any
circumstances. The power supply and handset contain
no serviceable parts.
3. Do not modify or make any changes to the power
supply, handset or other electrical devices.
4. During installation, repair, cleaning, or maintenance
work, the power cable must be disconnected from the
outlet.
5. The motors control unit is not designed for continuous
operation. Changing the desktop position without
interruption must not exceed the duty cycle indicated on
the power supply. The unit is thermally protected and
will temporarily shut down if use exceeds the duty cycle.
Allow a 9-minute cooling period for the control unit to
reset.
6. The power supply unit may only be operated with
voltage as specified on the power supply label.
7. Only use the power cord supplied with the power
supply. Check that it is not damaged. Do not operate the
power supply unit if the power cord is damaged.
8. Connect the power supply to a proper outlet only. To
disconnect turn all controls to the off position, then
remove plug from outlet.
9. In the event of a malfunction (e.g. if the control unit keeps
adjusting the desk because a movement button has
jammed), please unplug the unit immediately.
10. Do not expose the power supply, handset or other
electrical device to water or other liquids including
moisture, drips, splashes or spills. Only clean electrical
device with a dry cloth.
11. Do not operate the power supply, handset or other
electrical device in a potentially explosive atmosphere.
Do not operate where aerosol spray products are being
used or where oxygen is being administered.
12. Do not use the desk if it has been dropped or
damaged. Contact the manufacturer for examination or
repair.
13. It is not allowed to connect self-constructed products to
the power supply, handset or other electrical device. To
prevent damage, use only components recommended
by the manufacturing company.
©Knoll, Inc.
WARNING—Risk of
injury, or death
1. During the raising or lowering of the table there exists
a risk of squeezing or pinching between the moving
desktop and fixed objects.
2. The necessary safety margins depend on the greatest
type of injury risk that can be predicted. Where
possible small pinch points exist (i.e. fingers) use at
least a one inch (2,5 cm) safety margin and for body or
head (especially where children may be present) use
a minimum of 16 inch (41 cm) count from the floor or
from their top of the table feet if that is relevant.
3. During the lowering or raising of the desktop, the
operator must ensure that no person or object risk
being harmed by the operation.
4. This tag (at right) should be located on the table during
the initial installation.
5. Keep children away from moving parts and
underneath the table.
6. The intended use of the table is adjusting a work
surface between sitting and a standing position. The
table is not designed for other uses.
7. The table must only be operated while in an upright
position and must under no circumstances be
operated while upside down.
8. The table must not be overloaded. The maximum
allowable load is shown on the power supply label.
9. The table must be operated in a dry, enclosed space,
such as an office or similar, Do not operate outdoors.
10. The table is equipped with Collision Detection System
(CDS). In the event of a faulty components ( i.e. motor
or handset) the desktop may move slightly before the
safety feature is engaged. Stay clear of pinch points
when the desktop is moving.
11. This table is not intended for use by individuals
(including children) with limited physical, sensory
or mental abilities or with a lack of experience and/
or lack of expertise, unless they are supervised by a
person responsible for their safety or have received
instructions from that person on how to use the
control unit.
12. Children must be supervised at all times to ensure
that they do not play with the control unit.
13. The table may not be used to lift people. Do not sit or
stand on a table while it is be raised or lowered.
14. The table must not be structurally or technically
altered or modified in any way.
Tone Electric & Extended Electric - Stroke 665/420 User Manual 5