Crestron QM-FTCC Operations & Installation Manual page 25

Crestron QM-FTCC
Operations & Installation Guide – DOC. 6313B
QuickMedia™ FlipTop Computer Center
Mounting Parts Supplied with the QM-FTCC
PART DESCRIPTION
Screw #6-32, Pan Head, Phillips
Screw #10, Pan Head, Phillips
Mounting Bracket
* The QMI-FTCC is shipped with eight (8) #6-32 screws.
A Phillips screwdriver is required to mount the QM-FTCC to a surface.
1. Install the four supplied #6-32 screws, but do not tighten. Four are already
installed on the rear. These will be used to secure the front and rear
mounting brackets.
NOTE: For the QMI-FTCC, install the eight supplied #6-32 screws. None
are pre-installed.
2. Position the QM-FTCC in the mounting hole.
Mounting Bracket Screw Locations
3. Install the four #10 screws in the mounting brackets (two screws per
bracket). Refer to the following diagram.
4. Slide the mounting brackets over the #6-32 screws and tighten all eight
#6-32 screws.
5. Turn the four #10 screws equally until they contact the underside of the
mounting surface.
NOTE: Do not over-tighten the #10 screws as this may damage the surface and/or
the unit.
QuickMedia™ FlipTop Computer Center: QM-FTCC • 21
QUANTITY
4*
4
2