Flushmount fixture accessory for pat 4.0 (11 pages)
Summary of Contents for Panduit Atlona AT-VTP-FMK-10
Page 1
Flush Mount Kits for Velocity Touch Panels AT-VTP-FMK-10-BL The Atlona AT-VTP-FMK-10 is a flush mount kit for Velocity™ 10” touch panels. It allows the touch panel to be recessed into a wall so the panel face is virtually flush with the wall surface.
Installation Guide AT-VTP-FMK-10-BL Mounting Instructions Use the following steps to install the AT-VTP-FMK into the wall. Remove the inner two cut outs from the Perforated Wall Cutout Template. Just the outer ring should remain. 9 i n 8 . 0 .
Page 3
Installation Guide AT-VTP-FMK-10-BL Pull the Ethernet cable through the hole in the wall and thread it through the VTP-FMK. Slide the VTP-FMK into the hole in the wall until it is pressed fully against the wall. Press a screwdriver into the triangle metal flaps of the unit to secure the VTP-FMK into the wall.
Page 4
Installation Guide AT-VTP-FMK-10-BL *Optional* If mounting screws are installed in the Velocity Touch Panel, remove them from the back of the unit. Thread the screw into the magnet first, followed by the washer. Screw the group into the back of the Velocity Touch Panel. 10.