Ground The Device - Cisco Network Convergence System 540 Hardware Installation Manual

Install the Device

Ground the Device

Figure 17: Installing Cable Management (N540-CBL-BRKT-FHC) and ETSI Rack-Mount Brackets (N540-RKM-ETSI-FHC) in the Front
Ground the Device
Before you begin this task, ensure that you have read and understood the safety warnings in the Preventing
ESD Damage section of the Safety Warnings handout.
Before you connect the power or turn on the power to the device, you must provide an adequate device ground
(earth) connection to your device.
This section describes how to ground the device. The grounding lug location is on the back panel of the device.
1. Verify that the ground cable is connected to the top of the rack and according to local site practice.
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
37