Cisco Network Convergence System 540 Hardware Installation Manual page 5

C H A P T E R 5 Configure the Device
C H A P T E R 6 Replace Power Supply
C H A P T E R 7
Appendix
Connecting a Cable to the Input 10MHz or 1PPS Interface
Connecting a Cable to the Output 10MHz or 1PPS Interface
Connecting a Cable to the GNSS Antenna Interface
Install and Remove Transceiver Module
Safety Precautions for Module Installation and Removal
Install and Remove SFP56, SFP28, SFP10, and SFP Modules
Bale Clasp SFP56, SFP28, SFP10, and SFP Module
Install a Bale SFP56, SFP28, SFP10, and SFP Module
Remove a Bale Clasp SFP56, SFP28, SFP10, and SFP Module
Install and Remove QSFP+, QSFP28, or QSFP-DD Transceiver Modules
Required Tools and Equipment
Install the 40-Gigabit QSFP+, 100-Gigabit QSFP28, or 200/400-Gigabit QSFP-DD Transceiver
Module
54
Attach the Optical Network Cable
Removing the 40-Gigabit QSFP+, 100-Gigabit QSFP28, or 200/400-Gigabit QSFP-DD Transceiver
Module
56
Connect Interface Ports
57
Connect a Fiber-Optic Port to the Network
Disconnect Optical Ports from the Network
Maintain Transceivers and Optical Cables
59
Create the Initial Router Configuration
Verify Device Installation
63
Remove the DC Power Supply Module
Install the DC Power Supply Module
Remove the AC Power Supply Module
Install the AC Power Supply Module
67
LEDs
67
Router LEDs
67
Cisco Network Convergence System 540 Large Density Routers Hardware Installation Guide
46
47
54
55
57
57
58
59
61
63
64
65
66
45
46
47
48
49
49
50
51
Contents
v