Chapter 5 - Auxiliary Equipment Operation - Regal LS Series Owner's Manual

Chapter 5
Auxiliary Equipment Operation
Overview
This chapter will assist the boat operator in
understanding selected standard and optional
equipment components on the vessel.
equipment described may not be installed on your
boat or the pictorials and/or instructions may not
exactly fit equipment on your craft. Remember that
Regal is constantly improving its product line
and therefore may make changes in vendor parts
and specifications without notice. For detailed
information on equipment, please refer to the
owner's information packet. Note that all chain
windlasses use a chain stopper to remove
tension from the windlass itself.
Anchor Windlass
CLEAT LANYARD
HOOK
SAFETY WINDLASS
CLUTCH GIPSY
TYPICAL UNIT SHOWN
Select
SNAP CUTOFF ROPE
SWITCH LOCKER
WINDLASS
SWITCH
Anchor Windlass Introduction
If installed the windlass may feature a stainless
steel polished "claw" style anchor complete with
swivel. This anchor has high holding power in most
seabeds. Select windlass units offer all chain or a
rope-chain combination.
A momentary windlass rocker switch located at the
anchor locker controls the lowering and retrieving of
the anchor through the windlass. A 40 amp breaker
for windlass over current protection is located at
the battery management panel. There is a lanyard
with a snap hook to add holding power when the
anchor is in the stored position. The cleat is for tying
off the anchor rode rather than maintaining constant
pressure on the windlass itself.
FAIL SAFE
LEVER
CONTROL
ARM
ANCHOR
SWIVEL
ANCHOR
SHANK
SAFETY
PIN
116