PCB Piezotronics IMI SENSORS EX685A09 Installation And Operating Manual page 34

Certificate: 70031613
Project: 70153084
The manufacturer is required to apply the following markings:
•
Products shall be marked with the markings specified by the particular product standard.
•
Products certified for Canada shall have all Caution and Warning markings in both English and French.
Additional bilingual markings not covered by the product standard(s) may be required by the Authorities Having
Jurisdiction. It is the responsibility of the manufacturer to provide and apply these additional markings, where
applicable, in accordance with the requirements of those authorities.
The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for Canada and
US (indicating that products have been manufactured to the requirements of both Canadian and U.S. Standards) or
with adjacent indicator 'US' for US only or without either indicator for Canada only.
Nameplate adhesive label material approval information: CSA approve adhesive label material used for the
nameplate.
The following markings appear on the product:
1. Submittor's identification (company name and/or file number and/or registered tradename);
2. Marking on the unit that indicates the manufacturing location if the equipment is manufactured at more
than one factory location. Model designation;
3. Electrical rating;
4. Date of manufacture: Month and year of manufacture or date code. If a serial number is used instead of
date of manufacture, a record of serial numbers shall be kept traceable to date of manufacture. (Not
related to date of sale).
5. The products listed are eligible to bear the CSA Mark shown with adjacent indicators 'C' and 'US' for
Canada and US, or with adjacent indicator 'US' for US only, or without either indicator for Canada only:
, or , or
Note Jurisdictions in Canada may require these markings to be also in French. It is the responsibility of the
Customer to provide bilingual marking, where applicable, in accordance with the requirements of the Provincial
Regulatory Authorities. It is the responsibility of the Customer to determine this requirement and have bilingual
wording added to the "Markings".
Marking Method: The above markings are made via silk screening, die stamping, moulding or on CSA certified or
UL recognized adhesive nameplate material, compatible with the surface used; or other equivalent permanent
means that can pass the label rub test.
DOCUMENTATION
Equipment is accompanied by the following documentation.
General:
Technical specifications, instructions for use and details of where technical assistance may be obtained if
required.
Equipment Ratings:
DQD 507 Rev. 2012-05-22 Page 3
.
Master Contract: 184981
Date Issued: 2017-11-21