BRAYER BR1124 Instruction Manual page 7

• If the power cord is damaged, it should be replaced
by the manufacturer, a maintenance service or similar
qualified personnel to avoid danger.
• Do not repair the unit by yourself. Do not disassemble
the unit by yourself, if any malfunction is detected, and
after it was dropped, unplug the unit and apply to the
service center.
• Transport the coffee maker in the original package.
• Keep the unit out of reach of children and disabled
persons.
COFFEE MAKER IS INTENDED FOR HOUSEHOLD
USE ONLY, DO NOT USE THE COFFEE MAKER FOR
COMMERCIAL OR LABORATORY PURPOSES.
BEFORE USING THE COFFEE MAKER
After unit transportation or storage at low
temperature, it is necessary to keep it for at least
three hours at room temperature.
• Unpack the coffee maker and remove all the packaging
materials.
• Keep the original package.
• Read the safety measures and operating
recommendations.
• Check the delivery set.
• Examine the coffee maker for damages, in case of
damage do not plug it into the mains.
• Make sure that the specifications of power supply
voltage specified on the lower panel of the unit
correspond to the specifications of your mains.
• Wipe the surface of the coffee maker body with a clean,
slightly damp cloth to remove dust.
• Remove the Cover (8).
• Press on the locks and remove the filter holder (6).
• Wash all removable parts in warm water with a neutral
detergent: the coffee flask (2), the filter holder (6), the
filter (7), then rinse them and dry.
• Install the filter holder (6) back to its place and make
sure that the holder is fixed properly (6).
• Insert the reusable filter (7) into the holder (6).
• Fill about one half of the coffee flask (12) with pure
water and pour the water from the flask (2) into the
water tank (9).
• Close the lid (8) and put the flask (2) on the tray (1).
• Plug the power cord into an electrical outlet and the
flashing digital symbols (13) «12:00» will be displayed.
• Press the coffee maker on/off button « », the indicator
(17) will light up, the coffee maker will switch on, and
hot water will flow into the flask (2).
• Wait for the water to completely drain and then switch
the coffee maker off by pressing the coffee maker on/
off button (21) « » again, the indicator (17) goes out,
unplug the power cord from the electrical outlet.
• If necessary, you can switch the coffee maker off at any
time by pressing the on/off button (21) « ».
• Remove the flask (2) from the coffee maker and pour
the water out, if necessary, repeat the coffee maker
rinsing cycle 2-3 times.
EN 7