Advertisement
PSM200
STEP 2
BE CAREFUL TO ASSEMBLE ALL COMPONENTS IN THE SEQUENCE THAT
THEY ARE PRESENTED.
NOTE:
Finger tighten all hardware in this step. DO NOT wrench tighten until the last step.
some components may be pre-assembled. Nylon lock nuts will not fully screw onto
bolts, must wrench tighten.
2A. Insert each Chrome Guide Rods (D) into Left and Right Base Frames (A &B).
2B. Insert Rubber Stoppers (#9) into each Chrome Guide Rods (D).
2C. Insert Weight Bar (H) into each Chrome Guide Rods (D).
2D. Insert Chrome Guide Rods (D) into the Rear Uprights (E)
2E. Attach one Rear Upright (E) to Left Base Frame (A) using:
2 - (#1) m10x75mm hex head bolt
4 - (#3) m10 flat washer
2 - (#4) m10 nylon lock nut
1 - (J) steel bracket
2F. Attach the Rear Upright (E) to the left side of the Front Upright (C) using:
2 - (#1) m10x75mm hex head bolt
4 - (#3) m10 flat washer
2 - (#4) m10 nylon lock nut
1 - (J) steel bracket
2G. Repeat the same steps (2E & 2F) on the Right side (B) of the machine.
10
Advertisement
