Danfoss VLT AutomationDrive FC 302 Operating Instructions Manual page 64

Status Messages
Stop
Trip
Trip lock
Table 8.3 Operation Status
NOTICE
In auto/remote mode, the frequency converter requires
external commands to execute functions.
8 8
62
Operating Instructions
The frequency converter has received a stop
command from the LCP, digital input, or serial
communication.
An alarm occurred and the motor is stopped.
Once the cause of the alarm is cleared, the
frequency converter can be reset manually by
pressing [Reset] or remotely by control
terminals or serial communication.
An alarm occurred and the motor is stopped.
Once the cause of the alarm is cleared, power
must be cycled to the frequency converter.
The frequency converter can then be reset
manually by pressing [Reset] or remotely by
control terminals or serial communication.
Danfoss A/S © Rev. 2014-02-20 All rights reserved. MG34U302