Table of Contents
Advertisement
Precautions Before Use
This device complies with safety standard IEC/EN 61010-2-30 or BS EN 61010-2-030.
The leads comply with IEC/EN 61010-031 or BS EN 61010-031. The current
sensors comply with IEC/EN 61010-2-032 or BS EN 61010-2-032 for voltages up
to 600 V in CAT III.
Failure to observe the safety instructions may result in electric shock, fire,
explosion, destruction of the device, or destruction of the installations.
■
The operator and responsible authority must read and understand all
precautions needed before using the instrument. This instrument requires the
user to have knowledge and awareness of electrical hazards.
■
Observe the conditions of use, including temperature, relative humidity,
altitude, pollution degree, and location of use.
■
Do not use the instrument if it appears damaged, incomplete, or improperly closed.
Before each use, check the condition of the insulation on the leads, housing,
■
and accessories. Any items with a degree of deteriorated insulation must be
set aside to repair or discard.
■
All troubleshooting and calibration checks must be performed by competent,
accredited personnel.
Button Functions
Power & Energy Logger Model PEL 52 - Quick Start Guide
Measuring Terminals
Backlit LCD Display
Navigation Buttons
ON / OFF Button
■
To turn the device on, connect it to the
network at terminals V1 and N. Or press
the ON/OFF button until the device turns
on.
■
To turn the device off, press the
ON/OFF button until the device turns off.
You cannot turn the PEL off while it is
connected to a power source or while a
recording is in progress or pending.
Select / Control Button
Starts or stops a recording and allows
Wi-Fi mode to be chosen.
SD card slot
7
Advertisement
Table of Contents
