Table of Contents
Advertisement
5.2.3
Installing tag software using a debugger
C209 tag software can also be installed using a debugger connected through the J10 10-pin contact
on the PCB. To install C209 tag software with the pre-flashed DFU bootloader on NINA-B406:
1.
Download the
read the
releases
2. Unzip the downloaded file.
3. Connect the debugger to the 10-pin contact on the C209.
4. Flash the hex file from the folder named
the zip using your debugger.
☞
This operation will overwrite the boot loader on the module. The C209 GitHub repository
includes instructions for restoring the boot loader.
5.3 Configuration and handling
5.3.1 Configuring advertising interval
Press the SW2 button on the C209 to change the advertising interval.
When SW2 is pressed, the advertising interval cycles through the available advertising intervals. For
best performance, it is advisable to use the fastest advertising interval. The LED will blink shortly to
indicate the advertising interval, with 1 blink indicating the fastest advertising.
Figure 26: C209 with cover and buttons
C209 tags are simply configured over the UART interface using AT commands.
The AT commands that can be used to configure the interface are described in
Command
AT+UMLA=1
AT+GMM
AT+TXPWR=<valid_tx_power>
AT+TXPWR?
Table 7: C209 AT commands
☞
For
to take effect the software must be reset – either by pressing the reset button or power
+TXPWR
cycling the module. The configuration is persistently stored in flash.
All commands are echoed and responded with either
terminated with
\r.
☞
The UART interface is available for 10 seconds after reset with the settings 115200 bps, with no
flow control.
UBX-22006906 - R07
C1-Public
c209_aoa_tag_<version>.zip
section.
Description
Read Local MAC address
Read the model identifier, NINA-B4-TAG
<valid_tx_power> can be one of: -40, -30, -20, -16, -12, -8, -4, 0, 2, 3, 4, 5, 6, 7, 8 (dBm)
Query the set TX power
from the u-blox C209 software repository
release_c209_aoa_tag_no_boot_required
\r\nOK\r\n
C209 tag
XPLR-AOA-3 - User guide
in the unpacked
Table 7.
or
, and should be
\r\nERROR\r\n
[12]
and
[12]
Page 27 of 46
Advertisement
Table of Contents
