Programming The Touchscreen; Tips For Successful Programming; Programming Descriptions; Programming Procedures - Schlage ALLEGION BE469 User Manual

pRoGRaMMiNG tHE toUcHscREEN

Outside Schlage Button
• The first button you will
press in the programming
process.
• Can also be pressed
to exit programming
immediately.
green Check Mark
• Blinks when a number key
is pressed and when a
function is complete.

Tips for Successful Programming

L Watch the video before you begin! Browse
to answers.schlage.com and watch
User and Alarm Programming For
Touchscreen Deadbolt.
L The lock comes preset with a unique
default Programming Code and two unique
Default User Codes. Use these codes to
operate your lock or change them using
the instructions in this guide.

Programming Descriptions

Add User Code
Delete User Code
Change
Programming Code
Enable
Vacation Mode
Disable
Vacation Mode
Enable/Disable
Beeper
Delete ALL
User Codes
Enable/Disable
Lock & Leave
Change
User Code Length
Enable/Disable
Auto-Lock
Temporarily
Disable
Auto-Lock
Restore
Auto-Lock

Programming Procedures

L Determine how long you want your User
Codes to be BEFORE adding any User
Codes. If you change the User Code
6
User Codes unlock the deadbolt. Can be 4 - 8 digits long. All
codes must be the same length. See Change User Code Length
on page 7.
Removes one User Code at a time.
The Programming Code is used to put the lock into Programming
Mode. It is 6 digits long.
Prevents all user codes from unlocking the deadbolt . Enable for
extra security while you are away for an extended period of time.
Returns lock to normal operation.
The beeper can be turned off if desired. Beeps will still sound
during programming.
Removes ALL User Codes from the lock.
When enabled: Press the Outside Schlage Button to lock the
deadbolt. (Default setting).
When disabled: Press the Outside Schlage Button and then enter
a user code to lock the deadbolt.
User Codes can be 4 - 8 digits in length. Default is 4 digits.
Changing the User Code length will delete all existing User
Codes!
When enabled, the lock will automatically relock 30 seconds after
unlocking. (Disabled by default.)
Auto-Lock must already be enabled. While the deadbolt is locked,
press the Outside Schlage Button and then enter a 4-8 digit User
Code to unlock the deadbolt. Within 5 seconds, manually lock and
unlock the deadbolt using the thumbturn.
Lock the deadbolt using the thumbturn.
Red X
• If there is a problem during
programming, you will see
the red error X.
Programming Indicator
• Blinks when Programming
Mode is entered
• Solid while a programming
function is being
performed.
L Default Codes are located on the back of
the Alarm Assembly, and on the back of
this guide.
L If you would like to use a home automation
system to enable remote control of the
lock, refer to Enrolling on a Z-Wave
Network on page 13.
length, all existing User Codes will be
deleted!