Programming The Alarm; Powering The Alarm; Alarm Setting Descriptions - Schlage ALLEGION BE469 User Manual

pRoGRaMMiNG tHE alaRM

1

Powering the Alarm

The alarm is turned off by default. After installation, you'll need to turn on your alarm.
L Program the alarm using the Inside Schlage Button, shown below.
L Not sure your alarm is turned on? Simply press and release the Inside
Schlage Button once. It will beep and light up to confirm it is activated. If it
does not, try turning the alarm on again, and check the batteries.
L Watch the video before you begin! Browse to answers.schlage.com and
watch User and Alarm Programming For Touchscreen Deadbolt.
Turn the Alarm
ON
Turn the Alarm
OFF
L If you want to silence an alarm early, press and hold the Inside Schlage
Button until the alarm sound stops.
L Want to hear what the alarm sounds like in Activity or Forced Entry mode?
Enter an incorrect code four times and the alarm will sound.
2

Alarm setting Descriptions

Decide which alarm setting is best for you.
MODE
Activity
Alarms when the
door opens or
closes.
Tamper
Alarms when the
lock is disturbed,
while locked.
Forced Entry
Alarms when
significant force
pushes against the
door, while locked.
8
Press and hold
Release after first flash
(about 5 seconds)
Press and hold
Release after second flash
(about 6 seconds)
DESCRIPTION
Perfect for monitoring
doors while you're at
home.
• After the alarm is
triggered, there is
a built-in 3-second
delay for it to reset.
Senses subtle activity
at the lock.
Perfect for nighttime or
when you're away from
home.
• Least sensitive mode
– many choose to
use this alert setting
all the time.
LIghTS
Middle LED light
flashes
Left and right
LED lights flash
alternately
All lights flash
SOUNDS
Two short beeps
15 second Alarm
(90 dB=similar to
the volume of your
smoke alarm)
Three-minute shrill,
steady alarm
(90 dB=similar to
the volume of your
smoke alarm)