Installation; Preliminary Operations - Respekta AB140-26 Installation & User's Instructions

5 : INSTALLATION

5.1

Preliminary operations

5.1.1 Safety instructions for installation
Before installing the oven:
CAUTION: Before carrying out maintenance, cleaning or adjustment operations, the
appliance must be disconnected from the electrical supply.
WARNING: Install the appliance only in a suitable location.
WARNING: Make sure there are no structural obstructions in the space required for
installation.
WARNING: Make sure the materials adjacent to the installation space are heat resistant.
WARNING: Make sure the appliance is installed in compliance with all the applicable
safety regulations and standards.
WARNING: Make sure the power supply wiring incorporates a switch for complete
disconnection of the supply, positioned in a manner that complies with local regulations
on electrical wiring.
WARNING: Make sure the isolation switch is of the approved type, assuring a contact
gap of at least 3 mm on all poles (or on all active conductors [line] if the local wiring
regulations so allow).
WARNING: The isolation switch must be easily accessible by the user once the oven has
been installed.
WARNING: If in doubt concerning local regulations, consult the building code authorities.
WARNING: Ensure the power cable is not routed through kitchen unit doors or drawers
WARNING: The appliance must be installed by qualified personnel or technicians. Do not
attempt to install the appliance on your own under any circumstances.
The manufacturer declines all liability in the case of improper installation that results in
harm to persons or animals or damage to property.
en-34