Table of Contents
Advertisement
Fluidmesh 1200 VOLO
5.1.4. Supplying power to the Fluidmesh 1200 VOLO
The Fluidmesh 1200 VOLO can be provided with power using the
following methods:
• The included 24 Vdc passive PoE injector (90 Vac to 260 Vac,
50/60 Hz input).
• If connecting the unit to an Ethernet switch or router equipped with
unmanaged PoE, an IEEE 802.3af-to-24 Vdc inline converter
(Fluidmesh part number FM-POE-INL).
When providing the power source for the Fluidmesh 1200 VOLO,
remember the following important points:
• Install the power source as close to the unit as possible to minimize
voltage drop. The maximum suggested distance is 50ft (15m).
• Ensure proper grounding (earthing) and reliable connectivity by
using shielded CAT5/6 cables and connectors.
© 2020 Cisco and/or its affiliates. All rights reserved.
CAUTION
When connecting the Fluidmesh 1200 VOLO to a power
supply, the instructions in this section must be strictly followed
at all times.
Failure to follow these instructions may result in irreparable
damage to the unit and/or other connected hardware, and will
also invalidate the product warranty.
IMPORTANT
For technical data on which power sources are compatible with
the Fluidmesh 1200 VOLO, refer to
requirements" (page
154).
CAUTION
The Fluidmesh 1200 VOLO is designed to accept power from
the included 24 Vdc mode B passive PoE injector (Fluidmesh
part number FM-POE-STD) or from an IEEE 802.3af-to-24 Vdc
inline converter (Fluidmesh part number FM-POE-INL) only. Do
not connect power supplies of any other voltage output, type or
rating to the unit under any circumstances.
Do not connect an unmanaged PoE switch (in other words, a
PoE switch on which DC power to the RJ45 ports cannot be
switched off) to the Fluidmesh 1200 VOLO under any
circumstances. Connecting an unmanaged PoE switch to the
unit will result in 48 Vdc power being supplied to the unit. This
will irreparably damage the unit, and will invalidate the product
warranty.
"Electrical power
Page 29 of 169
Advertisement
Table of Contents
