Table of Contents
Advertisement
Fluidmesh 1200 VOLO
the RJ45 port of the Ethernet switch or router that is
connected to the PoE injector (below).
• If connecting the PoE injector to a non-PoE switch or router
(above), no special precautions need to be taken.
Connecting power to the Fluidmesh 1200 VOLO
Connecting power through a LAN RJ45 port
The Fluidmesh 1200 VOLO radio transceiver unit has two Ethernet ports
(Figure 8 (page
© 2020 Cisco and/or its affiliates. All rights reserved.
NOTE
For detailed comparative information on which Fluidmesh
hardware
devices
through IEEE 802.3at or IEEE 802.3af power sources, or
through a DC IN power source, refer to
requirements" (page
154).
32)).
are
capable
of
accepting
power
"Electrical power
Page 31 of 169
Advertisement
Table of Contents
