Table of Contents
Advertisement
Fluidmesh 1200 VOLO
To activate Plug-in Demo mode, do the following steps:
1.
Click the Demo Mode button at the bottom of the MANAGE
PLUG-INS dialog.
• The Demo Mode activation dialog will be shown
2.
To leave Demo mode before expiry of the 8-hour trial period, click
the Exit Demo Mode button.
• Demo mode will be deactivated, and the unit will reboot.
3.
If the 8-hour Demo mode limit is reached, the unit will reboot and
Demo mode will not be accessible again.
To upload one or more plug-in activation codes, refer to
management procedures" (page
To assign a software plug-in on the Partner Portal to the unit, do the
following steps:
1.
Enter the activation code for the plug-in in the Plug-in Activation
Code: field.
2.
Click the Add button.
• The plug-in will be activated, and the plug-in functionality
• A REMOVE link will be shown in red to the right of the
To deactivate an uploaded software plug-in for use with another
Fluidmesh unit, refer to
To show and erase the plug-in installation log files, do the following steps:
1.
Click the Show Logs button in the Plug-in Installation Logs:
section.
• The log files for plug-in installation will be shown in the
© 2020 Cisco and/or its affiliates. All rights reserved.
(page
126)). A countdown timer shows how much Demo
time remains.
Figure 65. MANAGE PLUG-INS dialog (Demo Mode
activated)
139).
can be used.
relevant plug-in description in the Plug-in List.
"Plug-in management procedures" (page
Plug-in Installation Logs: section.
(Figure 65
"Plug-in
139).
Page 126 of 169
Advertisement
Table of Contents
