Table of Contents
Advertisement
Fluidmesh 1200 VOLO
4.
To view a specific part of the graph, roll the mouse wheel forward
to zoom into the window, then click-and-drag the window left or
right.
5.
To reset the window to default size, click the Reset Zoom button
on the upper right-hand corner of the Spectrum Graph window.
To show all Fluidmesh wireless access points (APs) in the displayed radio
spectrum, do the following steps:
1.
Click the Show AP button on the upper right-hand corner of the
Spectrum Graph window.
• An icon representing each available access point will be
2.
To see detailed information for an access point, hover the mouse
cursor over the access point icon.
• The SSID number, MAC address and signal strength will
To see detailed information for the signal quality at each point in the
displayed frequency spectrum, click the Show Chan Quality button on
the upper right-hand corner of the Spectrum Graph window.
• A series of vertical bars will be shown for each occupied channel.
• Green bars indicate high signal quality. Yellow bars indicate falling
quality. If a bar is red, there is excessive signal noise at that
frequency.
To close the Spectrum Graph web page, click the Close Window
button on the upper right-hand corner of the Spectrum Graph window.
7.5. Network control
7.5.1. Ping softdog
The PING SOFTDOG window contains controls to set up a constant
series of pings to one or more IP addresses.
If connectivity is lost between the unit and any of the saved IP addresses,
an option can also be set to automatically reboot the Fluidmesh 1200
VOLO.
© 2020 Cisco and/or its affiliates. All rights reserved.
signal quality. Yellow indicates falling quality. If the signal
display is red, there is excessive signal noise.
IMPORTANT
If you are scanning a network with overlapping
communication channels, the number of
detected Fluidmesh units may be larger than
the actual number of deployed units.
shown on the Spectrum Graph window.
be shown for the chosen AP.
Page 71 of 169
Advertisement
Table of Contents
