Table of Contents
Advertisement
Fluidmesh 1200 VOLO
To change the RADIUS settings for the Fluidmesh unit, do the following
steps:
1.
Enable and configure network time protocol (NTP) as shown in
"NTP Configuration" (page
2.
Click the -radius link under ADVANCED SETTINGS in the left-
hand settings menu.
• The RADIUS dialog will be shown
© 2020 Cisco and/or its affiliates. All rights reserved.
IMPORTANT
The RADIUS feature is only available if the Fluidmesh 1200
VOLO is set to Mesh Point mode or Mesh End mode. If the
unit is set to Bridge mode, the -radius menu option will not be
available.
The RADIUS functionality will fail to operate if the network time
protocol (NTP) feature is not enabled and configured.
IMPORTANT
Use of this window requires extensive familiarity with the
RADIUS networking protocol. Do not change these settings
unless there is a specific need to do so.
109).
(Figure 53 (page
107)).
Page 106 of 169
Advertisement
Table of Contents
