Table of Contents
Advertisement
Fluidmesh 1200 VOLO
Figure 20. RACER™ Cloud connection info status (Disconnected)
Configure the unit by doing the following steps:
1.
Click the Reset to Provisioning button at the bottom of the
DHCP fall-back configuration section.
2.
Do a local (offline) configuration using the Configurator interface.
For further information, refer to
configurator interface" (page
For a quick overview of the initial configuration process, refer to the
flowchart below.
© 2020 Cisco and/or its affiliates. All rights reserved.
NOTE
Each individual Fluidmesh radio transceiver unit has a factory-
set mesh identification number that takes the form 5.w.x.y.
If the unit's IP address is set to 169.254.x.y/24 as in Case 2
below, the values x and y represent parts x and y of the unit's
mesh identification number.
"Device configuration using the
44).
Page 54 of 169
Advertisement
Table of Contents
