Table of Contents
Advertisement
6.16 Adjusting the Oxygen Cylinder
Holder
The oxygen cylinder holder (SS, Figure 49) allows supplementary
oxygen to be carried on the cot. The holder adjusts to fit various oxygen
cylinders. Remove the holder from the telescoping frame to adjust the
mount positions or to remove the cylinder-fastening straps for cleaning.
To remove the holder:
1.
Raise the backrest.
2.
Extend the telescoping frame.
3.
Remove any oxygen cylinders attached to the holder.
4.
Use a 4 mm hex wrench to remove the short screw (TT) from the
four corners of the oxygen cylinder mount. Retain the screws.
5.
Remove the oxygen cylinder mount and all washers
4 small washers (UU)
○
4 large washers (VV)
○
○
4 rubber washers (WW)
42
YY
iN∫X®
Do not operate the cot without the oxygen cylinder holder.
The holder must be attached to provide structural support for
the telescoping frame.
The oxygen cylinder holder must be detached from the
telescoping frame to remove the cylinder-fastening straps for
cleaning.
SS
NOTICE
TT (4x)
UU (4 x)
VV (4x)
WW (4x)
© Ferno / 234-3622-09 / December 2022
49
Advertisement
Table of Contents
