Table of Contents
Advertisement
4.9 Extend and Retract Buttons
Extend
and Retract
buttons (O, Figure 10) are affixed to the control-
end telescoping handle and guide bar. Button function is identical.
To activate the cot after turning the power switch ON, or to wake the cot
from Sleep Mode, press . Note: only
If the patient surface is not level when beginning to extend or retract,
the legs automatically equalize before extending or retracting together.
During the loading (page 29) and unloading process (page 30)
when the cot is supported by the ambulance floor, pressing
extend or retract only one set of legs at a time.
AUTOMATIC STOPS
The cot stops automatically at up to four heights: fully-lowered, fully-
raised, recommended transport height (factory-set), and the user-set
loading height. When the cot stops at the transport or user-set loading
height, press
or
again to continue extending or retracting the legs.
The cot stops at the user-set loading height only when extending. To set
the loading height, see page 44.
4.10 Sleep Mode
Sleep Mode conserves battery power. If the cot is not in use for more
than 10 minutes (no buttons pressed), the system enters Sleep Mode. In
Sleep Mode, the display and all lights are OFF.
The indicator light in the battery check button (F, Figure 11) will flash
every 4 seconds when the cot is in Sleep Mode.
Press the battery check button or
4.11 Mode-Select Button
Press the mode-select button (B, Figure 12) to cycle between direct
power modes and the set-loading height feature. Direct power modes
are rarely used. See page 31.
Each button press cycles to the next mode, with matching images on
the display. The button-press sequence is:
Direct power both legs
●
●
Direct power loading-end legs only
●
Direct power control-end legs only
Set loading height. See "Set the Loading Height" on page 44.
●
Standard operating mode
●
18
activates the cot.
or
or
button to activate the cot.
iN∫X®
will
O
F
B
© Ferno / 234-3622-09 / December 2022
10
11
12
Advertisement
Table of Contents
