4.23 Patient Restraint System
The patient-restraint system includes a combination pelvis strap/
shoulder harness, chest strap, and two-piece leg restraint (DD, Figure
26). For placement and operation, refer to the restraint users' manual
supplied.
4.24 Accessory Rail
The cot main frame (EE, Figure 26) acts as an attachment point to secure
a variety of accessories. Accessories may be attached to either side of
the cot, with a few limitations. For information on attaching, placing and
using accessories, see page 46.
4.25 Oxygen Cylinder Holder
The oxygen-cylinder holder (FF, Figure 27) is mounted to the telescoping
frame. It can carry a D or Jumbo D-sized portable oxygen cylinder, up to
a maximum 5.3" by 18.75" (135 mm x 476 mm). Spiracle Technology's
"DD-Lite" oxygen cylinder is also compatible.
To adjust the holder to fit a different cylinder, see "Adjusting the Oxygen
Cylinder Holder" on page 42.
To secure a cylinder on the holder:
1.
Center the cylinder on the holder. Wrap the fastening strap
around the cylinder and thread the strap through both D-rings
(GG, inset).
2.
Thread the fastening strap back through one D-ring (HH, inset).
3.
With one hand holding the oxygen bottle in place, pull the strap
to cinch it tight.
4.
Repeat to secure the second strap.
© Ferno / 234-3622-09 / December 2022
iN∫X®
DD
EE
GG
HH
FF
26
27
23