Table of Contents
Advertisement
4.20 Fold-Down Sidearm (Option)
Fold-down sidearms (AA, Figure 23) provide patient security and
comfort. To lower a sidearm, press the release button and lower the
sidearm. To raise a sidearm, lift the sidearm up until it locks into position.
Do not use fold-down sidearms or the SX Surface Xtender to
lift the cot. Grasp and lift only using the cot main frame.
4.21 SX Surface Xtender (Option)
SX surface extenders (BB, Figure 24) provide patient security and
comfort, and can widen the patient surface for large patients. SX also
provides a location to place a patient's arm to start an IV. Each side locks
individually. There are five locking positions and an unlocked, 'down'
position (Figure 24).
A safety feature prevents the mechanism from operating when there is
weight on the SX. To lower the SX, raise the SX slightly to take the weight
off the lock mechanism, squeeze the red release lever, and lower the SX
to the desired position.
To raise the SX, rotate the SX up to the desired position. There is no need
to use the release lever.
4.22 Non-Powered Operation
(Manual Mode Handles)
Manual mode handles (CC, Figure 25 inset) allow non-powered
operation in the event powered operation is unavailable. Each handle
allows one set of legs to be raised or lowered without power. The
handles are located under the shock frame (control-end legs) and below
the backrest (loading-end legs).
To access the handle, pull the handle out of its storage mount. To re-
secure, press the handle into the mount until it snaps into the locked
position.
Refer to the non-powered operation sections of this manual to operate
the cot manually.
22
NOTICE
iN∫X®
10°
27.5°
CC
AA
45°
52.5°
80°
BB
© Ferno / 234-3622-09 / December 2022
23
24
25
Advertisement
Table of Contents
