Table of Contents
Advertisement
2.6 Using Additional Help
Operating the cot requires a minimum of two trained operators. They
may need additional trained help when working with heavy loads
(patient plus equipment), or when operating the cot manually.
Two trained operators stand at the loading end and control end of
●
the cot, maintain control of the cot, operate the controls, and direct
helpers on where to stand and how to grasp the cot.
●
Side helpers may need to walk sideways under some circumstances.
Follow local protocols.
●
Ferno recommends that helpers work in pairs to help maintain cot
balance.
For heavy loads (patient weight exceeding 95th percentile male
●
and heavier), Ferno recommends a minimum of two trained
operators and two helpers.
●
Use special techniques when operating the cot without power.
Refer to the non-powered operation instructions in this manual.
Refer to the chart for suggested placement for operators and
●
helpers.
Extend/Retract
Extend/Retract
O
10
Heavy Patients (95th Percentile Male and Heavier), Ferno Recommends:
O
Key: O = Operator H = Helper
iN∫X®
Untrained helpers can cause injury or be injured. Trained
operators must operate the controls and direct helpers
where to grasp the cot to avoid pinch points.
700 lb
318 kg
50 st
Rolling
Rolling
O
WARNING
LOAD CAPACITY
Inspect the cot if the load capacity has
been exceeded (page 37).
Loading/Unloading
Loading/Unloading
O
© Ferno / 234-3622-09 / December 2022
Advertisement
Table of Contents
