Table of Contents
Advertisement
4.1 Display
The display screen inner surface is coated with a layer to protect it
against ultraviolet (UV) light and pressure damage. This clear surface is
normally invisible but may sometimes be seen as lines of clear "dots"
when viewed at an angle. This is normal.
Features include:
(A) Power switch (right side)
●
●
(B) Manual mode button (left side)
●
(C) Scene lights button
●
(D) Emergency lights button
(E) Chair position button
●
●
(F) Battery check button
●
(G) Display screen
4.2 Power Switch
The power switch (A, Figure 3) is located on the right side of the display.
Keep the switch in the ON ( ) position for all cot operations.
If the cot will not be used for more than 30 minutes, turn the power
switch OFF (
) to conserve battery power.
After 10 minutes of non-use, the cot will enter Sleep Mode to conserve
power. See "Sleep Mode" on page 18.
A powered Integrated Charging System (ICS, page 17) will disable the
cot powered mode and charge the battery when the cot is locked in the
fastening system.
4.3 Lights
The safety lighting system (Figure 4) features two types of lights that
illuminate the cot and surrounding area to increase operator and
patient safety. Both types are ON or OFF at the same time.
Drive Lights (H) are affixed to each actuator and provide steady
●
light to illuminate the ground around the cot.
●
Surround Lights (I) are white and red bar lights that span the length
of each side of the cot to increase cot visibility. These lights can
flash or provide steady light.
Use one of two buttons to turn the lights ON and OFF. An LED in the
upper-right corner of the button indicates the active light mode. Lights
also turn OFF when the cot enters Sleep Mode. See "Sleep Mode" on
page 18.
For steady "Scene Lighting" press the far-left display button (C, Figure 3).
The drive lights and surround lights illuminate with steady white light.
Press the button again to turn all lights OFF.
For flashing Emergency Lights, press the center-left button on the
display (D, Figure 3). The drive lights remain steady ON, but the surround
lights will illuminate and flash in a sequence of red-red-white. Press the
button again to turn all lights OFF.
14
iN∫X®
4 - FEATURES
Turn the power OFF when the cot will not be in use. See
"Storing the Cot" on page 39.
B
NOTICE
G
C
D
H
© Ferno / 234-3622-09 / December 2022
A
F
E
3
I
4
Advertisement
Table of Contents
