Table of Contents
Advertisement
MAINTENANCE AND TROUBLESHOOTING
MAINTENANCE
Regular maintenance is important for optimal per-
formance and to reduce wear. Inspect and properly
tighten all parts each time the rower is used. Replace
any worn parts immediately. Use only manufacturer-
supplied parts.
To clean the rower, use a damp cloth and a small
amount of mild detergent. IMPORTANT: To avoid
damage to the console, keep liquids away from
the console and keep the console out of direct
sunlight.
RAIL MAINTENANCE
Regularly clean the rollers beneath the seat and the
area of the rail over which the rollers move. First,
see assembly step 10 on page 11 and remove the Rail
End Cover (74) and the Rear Rail Bumper (38). Next,
remove the seat assembly from the rail. Then, use a
damp cloth and a small amount of mild detergent to
remove dust and debris from the rollers and from the
rail.
TROUBLESHOOTING
Some problems can be
solved with the simple
steps in this section.
Find the symptom that
applies, and follow the
steps listed. If further
assistance is needed,
go to my.iFIT.com, scan
the QR code at the right,
or call 1-833-680-IFIT
(1-833-680-4348).
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If you are having problems connecting the console to
a wireless network, or if you are having problems with
your iFIT account or iFIT workouts, go to my.iFIT.com.
If a replacement power adapter is needed, see
the Member Care contact information at the left.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
If the console does
not boot up prop-
erly, or if the console
freezes and does not
respond, reset the
console to the fac-
tory default settings.
IMPORTANT: Doing
this will erase all
custom settings you
have made to the
console. Resetting
the console requires two people. First, unplug the
power adapter. Next, locate the small reset opening
(A) on the top of the console. Using a bent paper clip,
press and hold the reset button inside of the opening,
and have a second person plug in the power adapter.
Continue holding the reset button until the console
turns on. When the reset operation is complete, the
console will turn off and then turn back on. If it does
not, unplug the power adapter and then plug it back in.
Once the console turns on, check for firmware updates
(see HOW TO CHANGE CONSOLE SETTINGS on
page 23). Note: It may take up to a few minutes for
the console to be ready for use.
27
A
Advertisement
Table of Contents
