Table of Contents
Advertisement
6. With the help of a second person, tip the rower
to the upright position.
Remove and discard the wire tie (not shown)
attaching the Main Wire (92) to the shipping
bracket (A). Then, remove and discard the
two shipping screws (B) and the shipping
bracket (A).
7. Avoid pinching the wires. Have a second
person hold the Console (6) and insert the
attached Neck (8) into the bracket on the Frame
(1). Attach the Neck with an M10 x 40mm Screw
(105); do not fully tighten the Screw yet.
Finish attaching the Neck (8) with an M10 x
65mm Screw (119). Then, fully tighten the
M10 x 40mm Screw (105).
Then, connect the Neck Wire (93) to the Main
Wire (92). IMPORTANT: The wire connectors
should slide together easily and snap into
place with an audible click. If they do not,
turn one connector and try again. You must
connect the wires correctly for the rower to
function correctly.
6
7
6
Avoid pinching
the wires
10
B
A
92
105
8
93
1
92
B
119
Advertisement
Table of Contents
