Table of Contents
Advertisement
HOW TO ADJUST THE DRIVE BELT
If you feel the strap slip while you are rowing, even
when the resistance is adjusted to the highest level,
the drive belt may need to be adjusted. To adjust the
drive belt, first unplug the power adapter.
Next, see assembly step 8 on page 11. Remove the
Right and Left Neck Shields (77, 78) from the rower.
Next, remove the Row Bar (19) from the Row Bar
Hook (88). Note: For clarity, the console is not shown
in the drawing below.
19
88
86
Then, remove the Flywheel Cover (86), the Strap
Cover (87), the Front Cover (79), the Bottom Cover
(80), and the Right and Left Shields (75, 76) from
the rower. To locate the screws that attach each
part, see EXPLODED DRAWING A on page 34.
IMPORTANT: There are different sizes of screws.
Make sure to note which size of screw you remove
from each hole.
Note: You will need the help of a second person to
tip the rower to the side so that you can access the
Bottom Cover (80).
76
87
75
79
80
Next, locate the
Drive Belt (99)
on the right side
of the rower.
Loosen the two
M10 x 20mm
Screws (101).
Next, tighten the
M10 x 55mm Set
Screw (42) until
the Drive Belt
is tight. Then,
tighten the two
M10 x 20mm
Screws.
When the Drive Belt (99) is tight, reattach the parts that
you removed.
29
101
42
99
Advertisement
Table of Contents
