GLP Impression X5 IP Bar 1000 Quick Start And Safety Manual page 16

www.glp.de
To install the impression X5 IP Bar 1000 on a rigging truss or pipe:
Check that the truss or pipe is secure and can safely hold ten times the weight
that it will support.
See Figure 6. Bolt at least one rigging clamp securely to each of the two rigging
brackets A that are supplied with the fixture using high-tensile steel screws or
bolts and self-locking nuts with washers passed through the slots B or central
hole C in the rigging brackets.
Fasten the two brackets A to the bottom of the base using four quarter-turn
fasteners B per bracket. Turn each fastener a full 90° to lock it.
Hold the fixture up to the truss and use the rigging clamps to fasten the fixture
securely onto the truss chord.
If there is any risk that the fixture will cause injury or damage if it falls, secure it
with a safety cable that is approved for the weight of the fixture, rigging
hardware, cables etc. as described in 'Securing the fixture with a safety cable' on
page 14.
16 impression
Figure 6. Rigging brackets
X5 IP Bar 1000 Quick-Start and Safety Manual
D
A
X5 IP Bar 1000
D
C
B